1/2HP LEESON 1725RPM 56HC TENV 3PH STAINLESS WASHDOWN BRAKE MOTOR 116483.00

LEESON Stainless Brakemotor is a positive, stop and hold brakemotor for use in washdown applications. Ideal for use in clean room and severe chemical-processing applications involving frequent washdown with nitric acid and caustic lye. Brakes are spring set. Load is stopped automatically when power is turned off. Featuring a power off manual release for convenience, and for use in case of a power failure. The manual release resets automatically. The standard brake is manufactured by Stearns. Features: 5/8" Keyed output shaft Combination 56H base has mounting holes for 56 and 143-5T All exterior components are 300-series stainless steel. Heavy duty 12G stamped base Nothing on the motor's exterior is painted or coated in any way. Interior coatings applied to rotor and stator protect against corrosion. All sealing components are Viton® for superior chemical resistance. Buna-N gaskets and Viton shaft seals (both ends for TEFC motors) IRIS Inverter rated insulation system Full fact nameplate is laser etched on the motor frame - no separately attached nameplate to trap dirt or contaminants. Double-sealed bearings are pre-lubricated with moisture-resistant high-temperature grease for long life. Four condensate drains in each endshield Moisture resisitant sealant between frame and endshields excludes water Split conduit box design with rubber gasket for better sealing Standards and Approvals : Single and three phase motors are UL component recognized - file number E57948, guide number PRGY2. CSA Energy Efficiency Verification Program, report number EEV 78720-1. Construction is CSA Certified for safety report LR33543