2HP WEG CFW08 VFD IP56 INDOOR 200-240VAC 1&3PH INPUT CFW080073BDN4A1Z

WEG CFW-08 WASH (IP56/NEMA4) Series is intended for speed control of three-phase induction motors. Designed for exclusively industrial or professional use, the VSD incorporates the most advanced technology and full features in a compact product, beyond a set of special functions available.
WEG CFW-08 VSD's are easy to install and operate. They are equipped with a optimized software that can be easily set through a Keypad, which enables them to process and control most of industrial machines.

Standard Features:

• WEG Standard Programing
• NEMA4(IP56) Enclosure
• V/Hz and Sensorless Vector Control
• 150% current overload capacity
• 16 bit DSP controlled PWM output
• 2.5 / 5 / 10 / 15 kHz adjustable swiching frequency
• Four isolated programmable digital inputs
• Display readings: Motor speed, frequency, voltage, current, last fault, heatsink temperature and drive status
• Two programmable relay outputs (1NO, 1NC, 240vac 0.5A)
• Two isolated programmable analog inputs (0-10V, 0/4-20mA)
• Protective features: Over current, motor overload, drive over temperature, output phase-to-phase and phase-to-ground short circuit, DC bus over and under voltage and external fault
• Control features: Linear and "S" ramp acceleration and deceleration, local/remote control, DC braking, torque boost, motor slip compensation, electronic pot, preset speeds, adjustable V/Hz profile, maximum and minimum adjustable frequency limits, two skip frequencies, adjustable output current limit, JOG, ride-thru, flying start and PID regulator.
• Ambient: 32ºF (0ºC) to 104ºF (40ºC), 3300ft (1000m) altitude, 90% humidity, non-condensing
• SuperDrive (G1) compatible

Special Functions and Resources Include:

• Password to enable programming
• Fault self-diagnosis and auto-reset
• Indication of specific quantity (programmable) - (e.g.: m/min, rpm, among others)
• Slip compensation (V/F control)
• Adjustable quadratic and linear V/F curve
• Self-tuning routine (sensorless vector control)
• Dynamic braking Momentary speed impulse function (Jog)
• Copy of the setting via serial operating interface - HMI (copy function)
• Linear and “S” type ramps
• Independent acceleration and deceleration ramps
• DC braking (direct current)
• Multispeed function with up to 8 preset speeds
• Selection of the direction of rotation
• Overlapped PID control (automatic control of level, pressure, etc.)
• Start with the motor spinning (flying start)
• Rejection of critical or resonant frequencies (skip frequency)
• Operation during momentary network faults (ride-through)
• Communication protocols: Modbus-RTU, CANopen and DeviceNet