DART CONTROLS 125 SERIES ANALOG SCR NEMA 4X DRIVE 125DV200EB-29-4

125DV200EB-29-4 DART Controls 125 Series Analog SCR NEMA 4X Drive is contained in a cast aluminum powder coated enclosure for wash down, outdoor, and food/sanitary applications. One drive will handle both 120VAC and 240VAC source power. Dart's standard auto-sensing voltage circuit means no jumper setting or wiring changes are necessary. The drives are fully adjustable across their HP ratings - no extra resistors to purchase or keep track of. Standard features include an inhibit circuit for start/stop operation and 1% speed regulation over a 50:1 speed range. Long life and quality are assured by 100% full load testing. HP Rating: 1/8 - 1HP @ 120VAC 1/4 - 2HP @ 240VAC Operator Controls: Pilot Light, Speed Pot, On/Off, FWD/STOP/REV, RUN/JOG Features: +/-10% rated line voltage Adjustable horsepower settings Barrier terminal strip Full wave bridge supply 1% speed regulation Adjustable minimum speed (0-30% of base) Adjustable maximum speed (66-100% of base) Adjustable IR compensation Adjustable current limit Jog - momentary switch will jog motor at speed pot setting Includes 4PDT center block (no pass) switch motor reversing. Cuts off power supply while changing motor direction. -10°C to +45°C ambient temperature Line voltage compensation 5K ohm speed potentiometer kit included 50:1 speed range Overload capacity: 200% for one minute Transient voltage protection Voltage follower mode - isolated signal (0-10VDC) Inhibit circuit - permits low power start and stop UL Listed